Mobile Storage Top Replacement Guide

Are you switching out your MojoDesk Mobile Storage top or need to tighten it? Then this is the guide for you!
You will need a Phillips screwdriver and flashlight.

 

Step 1: Remove the top drawer. 

Step 2: Locate the prongs on the left and right side of the open drawer

Use your finger to push DOWN on the right side (same side as keyhole)

 

 Use your other hand to press UP on the left side

Step 3: Continue this pressing/pushing as you completely pull out the top drawer. Lock the caster wheels to avoid it moving while pulling it out.  

This is how it will look when you’ve pulled it completely out

Step 4: Use your flashlight to locate the four screw points on the inside of your storage unit. 

This is an open/close clasp, so you will open each screw by inserting the Philips screwdriver and turning counterclockwise a 1/4 turn. 

 

Step 5: This is an open/close clasp, so you will open each screw by inserting the Philips screwdriver and turning counterclockwise.

Step 6: Lift off the surface top after all four screws have been loosened.

Step 7: Flip the surface top over to locate the black notch.

 Step 8: Place the surface top back onto the storage unit with the black notch in the front, right corner  and align the screws.

Step 9: Before tightening, make sure that the top surface is flush to the storage unit. Also that there is a lip in the front, but not in the back. Then, tighten all four points by moving the screwdriver clockwise.

Step 10: Place the top drawer back in, matching the sides like a puzzle piece. Use a wall or your foot to prevent the unit from wheeling around. The drawer will fit snuggly back into place.

Step 11: All done!